MIMAKI SWJ-320 S2 - Setting the Drying Fan; If Ruck Is Generated on the Printing Surface of the Media

2-22
Preparing for the Heaters
Setting the drying fan
1
Turn on the main power switch of drying fan unit.
• When turning off the power of unit, also, turn off the main power of drying fan.
2
Turing on the blower switch.
3
Turn on the switch of each drying fan
according to the position and width of
media.
If ruck is generated on the printing surface of the media
When you use the media such as thin FF, tarpaulin, tarpaulin, etc., if ruck is generated on the printing surface of
it, ruck may be improved with the temperature setting below:
 Set the temperature of the pre heater higher and that of the print heater lower.
e.g. Pre heater: 60 degrees, Print heater: 30 degrees
 Using the drying fan, lower the post heater temperature. (Or, turn off the heater.)
e.g. Post heater: OFF, Drying fan: ON, Blast fan: ON
Drying fan
Blowing fan
Blower switch
Drying fan unit
main power switch
Drying fan
left switch
Drying fan
center switch
Drying fan
right switch