2-17
1
2
Basic Operations
4
5
6
Setting a Media
Setting the printing area
When [MEDIA RESIDUAL] of the maintenance function is "ON" ( P.3-14), the screen for entering media
remaining amount is displayed after detecting the media width.
1
Press on the media selection screen, and
select ROLL/LEAF.
• When detecting roll media, the rear edge is detected during printing, and when there become no media,
“NO MEDIA” is displayed.
• When detecting leaf media, the rear edge is not detected.
• When detecting roll media, be sure to use the tension bar.
2
Input width of the printing area.
• Set the printing area in the Y direction.
If you know the printing width:
(1) Press to input the value.
(2) Press the key.
• The carriage moves.
If you do not know the printing width:
(1) Press the key to select "MANUAL".
(2) Press the key.
• The carriage moves.
3
Set the printing origin.
(1) Press to move the carriage to the print start
position (origin).
• Put an arrow mark of the carriage on the setting position.
(2) Press the key.
• If "MANUAL" is set on the Step 2, go to the Step 4.
• If a number is entered for the printing width on the Step 2,
the left end of the printing area is automatically adjusted to
the entered number, and the mode is returned to the
LOCAL. Skip the step 4.
4
Set the width of the printing area.
(1) Press to move the carriage to the left end of the
printing area.
• Put an arrow mark of the carriage on the setting position.
(2) Press the key.
• After capping, the screen returns to LOCAL.
• When detecting roll media, you cannot move the media with the key.
• When inputting the printing width with , be careful that it may print out of
the media depending on the print start position set on the Step 3.
• If you set the wrong printing area, detect again from the Step 1 after performing the operation below.
(1) Press the key.
(2) Press to select [MEDIA RESET].
(3) Press the key.
(4) Press the key.
To Next Page
Loading...
