MIMAKI SWJ-320 S2 - Connecting Cables; Connecting USB2.0 Interface Cable

1-9
1
Before Use
3
4
5
6
Connecting Cables
Connecting USB2.0 Interface Cable
Connect the PC and this machine with the USB2.0
interface cable.
Notes on USB 2.0 Interface
 When two or more machines are connected to one personal computer
When two or more SWJ-320S machines are connected to one personal computer, the personal computer may
not recognize all the SWJ-320S machines normally.
Reconnect the unrecognized SWJ-320S machine to another USB port, if available, and check to see if it is
recognized.If the SWJ-320S machine is not recognized by the newly connected USB port, use USB 2.0
repeater cables available on the market.
 Notes on peripheral devices in USB high speed mode
When a peripheral device (USB memory or USB HDD) to be operated in USB high speed mode is connected to
the same personal computer that a SWJ-320S machine is connected to, the USB device may not be
recognized.
When SWJ-320S is connected to the personal computer to which an external HDD is connected via USB, the
speed of data output to SWJ-320S may drop.That can cause the head unit to stop temporarily at the right or left
end during printing.
• Your RIP must be compatible with USB 2.0.
• Contact a RIP maker near your location or
our office when the USB2.0 interface is not
attached to the PC.
• Your RIP must be compatible with USB 2.0.
USB cable
USB 2.0 repeater cable