MIMAKI SWJ-320 S2 - Rear Side and Right Side of the Machine

Names of Parts and Functions
1-5
1
Before Use
3
4
5
6
Rear Side and Right Side of the Machine
Pre-heater
Preheats the media before printing.
(Located inside the platen)
AC inlet
Connect the power cable to the AC inlet.
LANconnector
LAN connector for service maintenance.
The customer shall not use this.
Main power switch
Turns on/off the main power for this
machine. Leave the main power turned on
to prevent ink clogging.
USB 2.0 connector
This is USB2.0 interface connector.
Feeding device
Main power switch
AC inlet of the heater
Connect the power cable to the AC inlet.
Drying fan AC inlet
Insert the power cable of Drying fan.