MIMAKI SWJ-320 S2 - Preparing for the Heaters; Setting the Heater

2-20
Preparing for the Heaters
Setting the heater
Set the heater temperature.
Set the heater temperature according to the media to use and environment conditions.
• It may take several minutes to tens of minutes for the set temperature to be reached, depending on the ambient
temperature.
1
Turn on the main power switch of heater
unit.
• When turning off the power of heater unit, be sure
to turn off the main power switch.
2
Turn on the power of each platen heater.
3
Set the temperature of each heater.
Shift :
Temperature set :
(1) Press .
•The set temperature is blinking.
(2) Set the temperature by pressing and .
(3) Press again to determine the set
temperature.
•The heater starts to get hot.
• When the power is not supplied even by turning on/off the power switch, check that the
main power switch of heater on the side of unit is ON.
• Use this machine under 20 to 30°C. The temperature may not reach the set value due to the
environmental temperature condition.
• Though you can enter up to 70°C on the heater temperature panel, to use the machine safely, the
upper limit of the setting value shall be under 60°C.
• Temperature displayed on heater temperature panel shows temperature inside the heater. If it touches
with media, the heater surface temperature will be lower than the displayed one, but this is not abnormal.
Heater main
power switch
Side of unit
Post-heater
temperature panel
Adsorption power
adjustment dial
Post-heater switch
Printing surface
light switch
Adsorption fan switch
Pre-heater
temperature panel
Print heater
temperature panel
Print heater
switch
Pre-heater switch
The set
temperature:
20 to 60°C
Current heater
temperature