MIMAKI SWJ-320 S2 - Setting Drying Time

3-4
Setting Drying Time
In the drying time setting, the following items for ink drying time are set.
• SCAN : Ink drying time for each scanning is set. (During bidirectional printing, the machine stops for a
certain period of time specified for each of the outward and return scanning.)
• PRINT END : Ink drying time after printing has been complete is set.
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [DRYING TIME].
4
Press the key.
5
Press to set drying time for scanning.
• To enable the drying time specified in your RIP, select “Host”.
• Scanning setting value : Host or 0.0 sec. to 99 sec.
6
Press the key.
7
Press to set drying time for after printing is
completed.
• To enable the drying time specified in your RIP, select “Host”.
• Print end setting value : Host or 0 sec. to 999 sec.
8
Press the key.
9
Press the key several times to end the setting.
• When you give priority to the setting at the RasterLinkPro side, make the setting value “Host”.
• “SCAN” set in this machine is displayed as “Pause Time per Scan” in the RasterLinkPro.
• You cannot specify the print end at the RasterLinkPro side. When you set this machine to “Host”,
printing will be performed in “PRINT END= 0 sec.” status.
FUNCT I ON
SETUP [ ENT ]
SETUP
FEED COMP . [ ENT ]
SETUP
DRY I NG T I ME [ ENT ]
SCAN
=HOST
SCAN
=HOST
PR I NT END
=HOST
PR I NT END
=HOST
SETUP
DRY I NG T I ME [ ENT ]