Troubleshooting
5-4
Nozzle is clogged
When nozzle clogging is not dissolved even after the head cleaning referring to P.2-25, make sure the following
operations.
Carry out the ink purge. of P.4-14.
Wash the head nozzle by the operations of P.4-16.
Recovery the nozzle by the operations of P.4-18.
When media heaves up at feeding
We call the status of heaving media at feeding “cockling”.
When media cockling occurs, check the following items:
Note/ checking items Measures
Checking media set status (1) Check that the media is set straight and reset it.
Adjusting heater temperature
(1) Raise the pre-heater temperature by 5 to 10 degrees.
(2) Lower all heaters’ temperatures. (When you lower the heater
temperature, drying time may not be enough. Lower the
FEED SPEED.)
Media feeding
(1) For roll media, feed the media by about tens of centimeters
to one meter.
(2) For leaf media, press and perform feed/ back
feed.
Do not leave the media in the heater warm-
ing status
(1) Do not start printing with the media cockled because it may
cause media jam.
Heighten the head (1) For the thicker media, raise the head height at printing.
To Next Page
Loading...
