MIMAKI SWJ-320 S2 - Setting a Narrow Roll Media

2-10
Setting a narrow roll media
1
Remove the screw and feeding gear cover.
2
Take off the narrow roll shaft from the feeding
device.
3
Set the narrow roll media to the narrow shaft and
place the media in the center of the shaft.
• Fix the media with the attached roll holder.
• Attach the feeding gear cover.
4
Pass the media through under the tension bar and feed the
media a little longer.
• Pull the media out of the roll so that the media can be grasped from the
front of the machine.
• Use the narrow roll media holder only for the media of 25kg and less.
Feeding gear cover
Narrow roll shaft
Roll holder
Narrow roll media
Roll holder
Tension bar
Route for the paper of its print-
side outside.
Route for the paper of its print-
side intside.