MIMAKI SWJ-320 S2 - Setting Roll Media - Steps 9-13

2-9
1
2
Basic Operations
4
5
6
Setting a Media
9
Feed the media to the tension bar.
(1) Pressing the key, feed the media until the
tension bar at the rolling side is being hidden.
• Check the media end is not caught into the slot on the
post-heater, and then feed the media.
10
Fix the media to the roll shaft.
(1) Lift the tension bar by hand to the full top position.
(2) Put the media under the tension bar and fix the
media at the center of the roll shaft with an
adhesive tape.
(3) In the same manner, fix the left side and right side
of the media.
• Pull roll media evenly for right and left, check that
there is no slack or waviness on the media, and
paste tape in numerical order.
• When you place the tape, consider the rolling-up
direction.
11
Roll up the media.
(1) Set the taking-up direction switch to “Forward”/
“Backward” according to the taking-up method.
(2) Press , and rotate the roll shaft 2-3 times to
take up the media.
(3) Press the key.
12
Hold the media with the media press gently.
• Set the media so that no media sticks out from the right end
pinch roller to the right side.
• Set the media press to the position of 3mm away from the
media.
• When using a thick media, remove the media press from
the media before printing.
13
Close the front cover.
• If you raise the tension bar while
holding the center of it, the bar may
bend. When raising the tension bar, be
sure to hold the bar edge.
• Setting the Feeding manual switch at the
"Manual" position and turning ON either of
the upper or the lower sides of the Feeding
direction switch, rolling up will start.
When stopping, set the Feeding direction
switch at the neutral position (OFF), or turn
the Feeding manual switch at the "AUTO"
position.
Roll up with the
print-side inside.
Roll shaft
Tape
Backward
Roll up with the
print-side outside.
Forward
Tension bar
Media press