MIMAKI SWJ-320 S2 - Setting Roll Media - Steps 7-8

2-8
7
On the backside of unit, set the feeding device.
If the print-side is inside of roll,
(1) Set the Feeding direction switch at the “Backward” position (upward).
(2) Set the Feeding manual switch at the “Auto” position (downward).
8
Prepare for the take-up device.
(1) Set the taking-up direction switch to “OFF” (Center)
(2) Set the taking-up manual switch to “Auto” (Lower)
• If the print-side is outside of roll,
Set the Feeding direction switch at the “Forward” position (downward).
• Set the Feeding manual switch at the “Manual” position (upward).
Auto
Manual
Forward
Feeding with the print side
facing to the outside.
OFF
Not operated.
Backward
Feeding with the print side
facing to the inside.
Feeding direction switch
Feeding
direction switch
Print-side is
inside:
Print-side is
outside:
Backward
Forward
Roll shaft
Auto
Manual
Forkward
Taking-up with the print side facing to
the outside.
OFF
Not operated.
Backward
Taking-up with the print side facing to
the inside.
Taking-up
direction switch
Taking-up direction switch