MIMAKI SWJ-320 S2 - Ink Bottle Replacement and Charging; Replace Ink Bottle Procedure

1-11
1
Before Use
3
4
5
6
Ink bottle replacement and charging
This unit manages the use-by date and the amount of ink remaining by reading the information of ink IC chip
attached on the ink bottle.
Replace the ink bottle, according to the following procedures.
1
Replace the inkbottle.
(1) Remove the bottle cap.
(2) Insert the ink pipe near the center of the inside pig.
2
Insert the ink IC chip into the ink IC slot.
• Use the IC chip attached on the ink bottle.
• Insert the ink IC chip facing the contacts of IC chip up.
3
Confirm the information of ink IC chip, and press
key.
• Confirm the color, ink type, capacity displayed on the
display. If incorrect, press key and reenter.
• When an error message such “ WRONG INK IC ” is
displayed, remove the IC chip once and reinsert it.
4
Confirm the charge completion display.
• When the ink charging is normally completed, the new ink
remaining amount is displayed.
• Reinsert the IC chip when an error occurs.
• Be sure to check the type and color of
ink to be set before replacement.
• If its insertion is not enough, it becomes
impossible for ink to use up to the last.
• In such a case, widen the insertion of
inner cap until the pipe can move
downward with its own weight.
If the pipe moves upward, you cannot
use ink up to the last.
• Do not dirty or damage the contact of ink IC
chip.
It may cause not to read the stored
information correctly.
• The ink IC chip charged once cannot be
undone.
Be sure to press key after the
displayed information is confirmed.
• Do not remove the ink IC chip during charging. It may cause a trouble of unit or ink IC chip.
Fitting
<LOCAL>
w i d t h : 1000mm
COL : K CS100 : 2000cc
CHARGE START [ ENT ]
Contacts
of IC chip
IC chip
** CHARG I NG **
DON’T REMOVE I NK I C
COMPLETE I NK CHARGE
COL : K CS100 : 2000cc
IC chip information
(In charging)
Charging completion