2-5
1
2
Basic Operations
4
5
6
Setting a Media
This machine can be used with a roll media and leaf media.
For usable medias, refer to P.1-13 “Usable sizes of media”.
Note for media setting
When setting media, read the following notes carefully.
Setting a roll media
Here, the setting procedures when the print surface faces outside are explained.
1
Put the roll media onto two shafts on the backside
of unit.
• Put roll media at the center of the shaft.
2
Set the roll guide for right and left.
(1) Move the roll guide to the position of 1mm away from
the media (paper core).
• Take care not to drop the media on a foot or so when the media is set. It may cause an injury due to
the media.
• Set a media after turning OFF the Drying fan and the Blowing fan.
• Be sure to set the media with two or more persons.
• When setting the media, fully be careful so that you may not clip your finger etc. between the media
and the machine.
• Narrow roll media may slip on the shaft and feeding cannot be performed properly. For setting a
narrow roll media, refer to "Setting a narrow roll media"( P.2-10)
To Next Page
Loading...
