MIMAKI SWJ-320 S2 - Setting Roll Media - Steps 3-4

2-6
(2) Rotate the knob and fix the roll guide.
(3) Check that the roll guide is attached vertically against
the feeding roll shaft.
(4) Feed the media and check that the roll guide does
not apply any stress on the media/ the paper core.
3
Pass the media through under the tension bar and
feed the media a little longer.
• Pull the media out of the roll so that the media can be grasped
from the front of the machine.
• If you perform printing with the status
that the roll guide applies stress on the
media/ the paper core, it is possible to
detect media end by mistake.
Rotate the knob and fix
Media
Roll guide
Roll shaft
Media
Roll guide
Roll shaft
Roll Roll
Tension bar
Route for the paper of its print-
side inside.
Route for the paper of its print-
side outside.