MIMAKI SWJ-320 S2 - Media; Usable Sizes of Media; Caution in Handling of Medias

1-13
1
Before Use
3
4
5
6
Media
Usable media sizes and notes for handling are described.
Usable sizes of media
Caution in handling of medias
Pay attention to the followings for handling of medias.
Model SWJ-320S
Type of Recommended media
Tarpaulin/ FF(Flexible Face)/ PVC
Maximum width
3250 mm
Minimum width
210 mm
Maximum printing width
3200 mm
Roll media
Thickness
1.0 mm or less
Roll outside diameter
Feeding device Maximum: Φ220 mm
Take-up device Maximum: Φ120 mm
Roll weight
Feeding device Maximum: 100 kg
Take-up device Maximum: 40 kg
Roll inside diameter
3 inch
Side printed
Roll inside/out side Both possible
Roll end treatment
The roll end is gently fixed to the core with weak-adhesive tape or weak glue
for easy removal.
• Wear gloves when handling the media.
Take care not to touch the media with bare hands since the media may be dirtied by the fingerprints or
fat of hands.
• Do not leave the heater ON a long time in the condition that the media is set.
The media becomes wavy, and this causes the media jamming.
• Use media recommended by MIMAKI to ensure reliable, high-quality printing.
Set the heater temperature to meet the characteristics of the media.
• Set the temperature of the Pre-heater, Print heater and Post-heater according to the type and
characteristics of the media used.
Set the temperature of pre-heater and print heater according to the type and characteristics of media.
• Pay attention to the expansion and contraction of the media.
Do not use media immediately after unpacking. The media can be affected by the room temperature
and humidity, and thus it may expand and contract.
The media have to be left in the atmosphere in which they are to be used for 30 minutes or more after
unpacked.
• Do not use curled media.
This may result in paper jamming.
If a regular-sized coated sheet of media is rolled and stored, the coated side has to face outside.
• Be careful to dusts on the edge face of the medium.
Some rolls have dusts contained in the package gathered on the edge surface of the roll. If you use as
it is, the drawing quality may be degraded due to nozzle missing or ink drops. Be sure to set the roll
after removing dusts adhering on the edge face of the roll.