MIMAKI SWJ-320 S2 - Printing Data; Starting a Printing Operation

2-34
Printing Data
Starting a Printing Operation
1
Setting a Media ( P.2-5)
2
Transmit data to be printed from the PC.
• The ACTIVE lamp blinks and the printing
conditions are displayed.
• For the method of data transmission, see the
instruction manual for the output software.
3
Start printing.
Printing mode list
• When using a roll media, rewind the media before printing so that it is not loose. When the roll media
has not been rewound tightly, it may cause the image quality to deteriorate.
X resolution Y resolution Pass
Double speed scan
*1
*1. In the printing mode with O mark, you can print with either of “Double speed” and “Standard speed”.
In the printing mode with X mark, you cannot print with “Double speed scan”. You can use only “Standard
speed”.
Maximum printing
width
*2
*2. For 1,080dpi of Y resolution, the maximum printing width is 3,000mm.
If you want to perform printing of 3,200mm-width, use 360dpi/ 720dpi to print.
360dpi 600dpi
2×
3,200mm
4O
8O
720dpi
600dpi
2×
4O
8O
900dpi
3×
6O
12 O
1080dpi
600dpi
2×
3,000mm
4O
8O
900dpi
3×
6O
12 O
*REMOTE* 700x 600 R
16 .Bd .Vd . x2 xx . xxm
Resolution : 700 / 600 DPI
Number
of passes
The length of media drawn
Scan direction
Ud : Unidirectional
Bd : Bidirectional
Data type
Vd : Variable data
Nd : Normal data
Scanning speed
x1 : Standard speed
x2 : Double speed
With/ without nozzle
recovery setting