MIMAKI SWJ-320 S2 - Head Cleaning Procedures; Performing Head Cleaning

2-25
1
2
Basic Operations
4
5
6
Head Cleaning
About head cleaning
Check the printed test pattern result and perform cleaning depending on the status.
Select one from the three types below:
SOFT : When lines are bent, when any line is missing
NORMAL : When any line is missing, when colors are mixed
HARD : When poor image quality cannot be improved even by NORMAL or SOFT cleaning
Perform head cleaning depending on the test printing result
There are three types of head cleaning. Use one by checking the test pattern.
1
In Local, Press the key.
2
Press to select the cleaning type.
SOFT : When lines are bent, when any line is missing
NORMAL : When any line is missing, when colors are mixed
HARD : When poor image quality cannot be improved even by NORMAL or SOFT cleaning
3
Press the key.
4
Press to select a head to use.
• The cleaning of head indicated by the number is carried out.
• Select the head for cleaning by pressing , and then
select “Cleaning Yes/No” by pressing .
• When selecting “Cleaning No”, display “_” by pressing
.
5
Press the key.
• On completion of cleaning, this machine returns to LOCAL.
6
Perform test printing again, and check the result.
• Repeat the cleaning and the test printing until the drawing result becomes in normal.
When the image quality is not improved after the head cleaning.
• Clean the wiper and ink cap. ( P.4-5)
• Ink purge ( P.4-14)
• Wash the head nozzle. ( P.4-16)
• Solve the failure of the image quality, referring to When Nozzle Clogging Cannot Be Solved.
( P.4-18)
CLEAN I NG
SOFT L [ ENT ]
CLEAN I NG
HARD [ ENT ]
SELECT HEAD
:1234
SELECT HEAD
:1___
Head array of
SWJ-320S2
Head array of
SWJ-320S4
** CLEANING **
00 : 00 : 00