MIMAKI SWJ-320 S2 - Set the Scanning Speed and the Feeding Speed During Printing

3-9
1
1
3
Convenient use
5
6
Set the scanning speed and the feeding speed during printing
Set the print head moving speed and the media feeding speed during printing.
 SCAN SPEED
Set the print head moving speed during printing.
If you print in a hot environment or when you print a thick data, nozzle missing may occur in a short time. At
this time, change the scanning speed setting.
By slowing down the scanning speed, you can reduce nozzle missing.
 FEED SPEED
Set the media feeding speed during printing.
By speeding up the feeding speed, it takes less time to complete printing. However, the media feeding
accuracy may be degraded.
In addition, as dryness time of printing becomes shorter, fully check on the media you use before changing
the setting.
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [PRINT SPEED].
4
Press the key.
5
Press to set resolution.
• Set Value : 540dpi,720dpi,1080dpi
6
Press the key.
7
Press to set scan speed.
• Set Value : 70% to 100%
8
Press the key.
FUNCT I ON
SETUP [ ENT ]
SETUP
FEED COMP . [ ENT ]
SETUP
PR I NT SPEED [ ENT ]
PR I NT SPEED
: 360dp i
PR I NT SPEED
: 360dp i
SCAN SPEED
=100%
SCAN SPEED
=100%
FEED SPEED
=HOST