MIMAKI SWJ-320 S2 - Aligning the Print Result Lengths; Setting Feed Check Pattern

2-30
Aligning the Print Result Lengths
Apply this correction if the length is excessively long even when applying feed correction when the feed
direction is lengthwise.
Setting Feed Check Pattern
A pattern for media correction is printed and a media-feeding rate is corrected.
1
Set a media. ( P.2-5)
2
Press the key in LOCAL.
3
Press to select the [X-DistanceComp].
4
Press the key.
5
Press to select resolution.
• Select a resolution that is the same the actual printing.
6
Press the key.
7
Press to set number of pass.
8
Press the key.
9
Press to set scan speed.
• Do not perform feed correction after applying this correction. This correction becomes disabled.
• Even if this correction is applied, the distances will not match if the radius of the media roll being rolled
up/let out changes. Re-apply this correction if the roll radius changes.
• Revise this correction if the media type or width changes.
• The following accident error might occur even if this correction is applied.
±Whichever is larger: ±1.5 m or ±0.3% of the specified distance.
• Select a speed that is the same the actual printing.
• Not displayed for print modes that cannot scan at high speed.
FEED COMP .
<ENT>
X-Di stanceComp.
[ENT]
X-Di stanceComp.
RESOLUT ION: 360x600
X-Di stanceComp.
RESOLUT ION: 720x900
X-Di stanceComp.
PASS : 6
X-Di stanceComp.
PASS : 12
X-Di stanceComp.
SCAN SPEED:HIGH
X-Di stanceComp.
SCAN SPEED : NORMAL