MIMAKI SWJ-320 S2 - Page 55

2-29
1
2
Basic Operations
4
5
6
Checking the media feeding amount deviation during printing
10
Press the key to close the setting.
• The pattern is printed on the right side of online printing.
Overview of Patterns
 Pattern1
Check the feeding amount deviation by using the solid-fill pattern.
 Pattern 2
Check the feeding amount deviation by using overlapping lines.
• If you have checked the feeding amount deviation during printing, you can press the
key of the remote to correct the feeding amount during printing.
(P.2-27)
• This function might be disabled during 3Pass/Pass printing depending on the MAPS speed set value.
MAPS settings that disable this function:
3Pass: OFF / -40% to +50%
6Pass: +20% to +50%
Feeding amount is correct Feeding amount is large Feeding amount is small
Reduce the feeding
correction value
Increase the feeding
correction value
Gap in between
the patterns
Patterns
overlap?
No gaps
between or
overlapping of
the patterns
Feeding amount is largeFeeding amount is correct
Middle lines are
consistent.
Reference line
Check line
Feeding amount is small
The distance of the
reference and check
lines on the device
inner side are closer
than the lines in the
middle.
The distance of the
reference and check
lines on the device
outer side are closer
Reduce the feeding
correction value
Increase the feeding
correction value
Reference line
Check line
Reference line
Check line