3-5
1
1
3
Convenient use
5
6
Perform setting to reduce stripes between passes
In case that feeding stripes cannot be resolved even though media correction ( P.2-26) is performed, make
“MAPS (Mimaki Advanced Pass System) valid. Feeding stripes become less visible by distributing the pass
boundary.
(Supported from the firmware ver.2.00)
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [MAPS].
4
Press the key.
5
Press to set ON/OFF.
• Set Value : OFF, ON
6
Press the key.
• When you select OFF, proceed to the Step 11.
7
Press to change print pattern.
• Set Value : PATTERN1 / PATTERN2
8
Press the key.
• The color might change if MAPS is enabled. Check this beforehand.
• MAPS effect differs depending on the set value of the printing speed. Use it after checking effect in
advance.
• When you speed up the printing speed, it takes shorter time to print. However, MAPS effect becomes
weak.
• When you slow down the printing speed, it takes longer time to print. However, MAPS effect becomes
strong and feeding stripes become less visible.
• When printing, if you set the printing speed to 0% and more, MAPS becomes invalid. In addition, it
prints at 0% speed. When you use MAPS, set the printing speed to “minus (-)”.
• The MAPS effectiveness varies depending on the printed image.
When changing the print pattern, check the effectiveness before using the MAPS function.
Resolution Pass Scan speed Resolution Pass Scan speed
360x600 2Pass Normal speed 1080x600 2Pass Normal speed
540x600 2Pass Normal speed 1080x600 4Pass High speed
720x600 2Pass Normal speed 1080x900 3Pass Normal speed
720x600 4Pass High speed 1080x900 6Pass High speed
720x900 3Pass Normal speed 1080x1200 4Pass Normal speed
720x900 6Pass High speed 1080x1200 8Pass High speed
To Next Page
Loading...
