MIMAKI SWJ-320 S2 - Function Settings - Auto Cleaning

3-7
1
1
3
Convenient use
5
6
Setting Auto Cleaning
You can set up to perform the head cleaning automatically after the print of the pre-set number of pages or
distance was completed.
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [AUTO CLEANING].
4
Press the key.
5
Press the to select the [PAGE] or [LENGTH].
6
Press the key.
7
Press to set a cleaning interval.
• Set value PAGE: OFF / 1 to 1000 page
LENGTH: OFF / 0.1 to 100 m
• When selecting OFF, proceed to Step 10.
8
Press the key.
9
Press to set a cleaning type.
• Set value : NORMAL / SOFT / HARD
10
Press the key.
11
Press the key several times to end the setting.
• Depending on the state of the heads, etc., the image quality deterioration may not be improved even
with this function performed.In this case, contact our service office or the distributor in your region.
FUNCT I ON
SETUP [ ENT ]
SETUP
FEED COMP . [ ENT ]
SETUP
AUTO CLEAN I NG [ ENT ]
SETUP
AUTO CLEAN I NG [ ENT ]
AUTO CLEAN I NG
:PAGE
AUTO CLEAN I NG
:LENGTH
INTERVAL
=OFF
INTERVAL
= 1page
INTERVAL
=0.1m
TYPE
:SOFT
TYPE
:NORMAL