3-10
Set the scanning speed and the feeding speed during printing
9
Press to set feed speed.
• Set Value : HOST/70% to 100%
10
Press the key.
11
Press the key several times to end the setting.
• When you slow down the scanning speed, it takes more time to complete printing.
If you want to prevent the printing speed from slowing down, perform setting of the feeding speed
depending on the scanning speed setting by referring to the table below:
• When you set the feeding speed to 100% and more, the media feeding accuracy may be degraded.
Be sure to check on the media you use before changing the feeding speed.
• The values in the table below are the reference when the printing area is 3,200mm.
The printing speed changes depending on the printing area width, the media setting position and the
data to be printed. Check in advance before changing the feeding speed.
Reference value of feeding speed corresponding to each scanning speed to make printing speed same
(for 3,200mm wide printing))
SWJ-320S2 SWJ-320S4
Scan Speed
70% 80% 90% 70% 80% 90%
540x600dpi
2pass Bi *1 *1 300% *1 300% 130%
4pass Bi *1 *1 *1 *1 *1 300%
8pass Bi *1 *1 *1 *1 *1
720x600dpi
2pass Bi *1 *1 300% *1 150%
4pass Bi *1 *1 300% *1 300%
8pass Bi *1 *1 300% *1 *1
720x600dpi
Hi speed
4pass Bi *1 *1 300% *1 150%
8pass Bi *1 *1 300% *1 300%
*1: Condition when printing speed does not become the same even if you set the feeding speed to 300%
To Next Page
Loading...
