When Nozzle Clogging Cannot Be Solved
4-17
1
1
1
4
Routine Maintenance
6
Clean the cap rubber and cap rubber cover.
• Wipe off the ink sticking to the cap rubber and cap rubber
cover with a clean stick dipped in cleaning solution for
maintenance. Wipe off so that cleaning solution for
maintenance will not remain.
• At this time, the discharge passage is cleaned automatically.
7
Press the key.
8
Fill up the cap with cleaning solution for
maintenance．
• Take the maintenance washings to a dropper, and fill the cap.
Fill the cap with the washings just until the washings
overflows from the cap.
9
Close the right maintenance cover then press the
key.
10
Press to set the time for the cleaning
solution to be left as it is.
• Set value : 1 to 99 minutes (Unit: minute)
11
Press the key.
• The cleaning solution filled in the cap is absorbed.
• The screen on the right is displayed only for the duration set in the
step 9.
• It returns to the step2 after the duration.
• Until washing liquid is filled, [COMPLETED (NEXT): ENT] is displayed on the screen. After
the work up to the Step 6 is completed and you close the right maintenance cover, press
the key. If you press the key before washing liquid is filled, the
carriage returns to the original position.
• The ink clogging is not still eliminated even after several ink purges or nozzle washing have been
carried out, execute the nozzle recovery. ( P.4-18)
• When the image quality is not improved after the nozzle recovery, contact to a dealer or our sales
office (service calls).
To Next Page
Loading...
