MIMAKI SWJ-320 S2 - Chapter 2: Basic Operations

This chapter
describes procedures and setting methods for ink and media preparation, and printing.
Workflow .......................................................2-2
Turning the Power ON/OFF ..........................2-3
Turning the Power ON ................................ 2-3
Turning the Power OFF ............................... 2-4
Setting a Media .............................................2-5
Note for media setting ................................. 2-5
Setting a roll media ..................................... 2-5
Setting a narrow roll media ....................... 2-10
Adjusting the Head Height ........................ 2-14
Setting the printing area ............................ 2-17
Setting leaf media ..................................... 2-18
Changing the printing origin ...................... 2-19
Preparing for the Heaters ............................2-20
Setting the heater ...................................... 2-20
Setting the adsorption fan ......................... 2-21
Setting the drying fan ................................ 2-22
If ruck is generated on the printing surface
of the media .............................................. 2-22
Test Printing ................................................2-23
Test Printing ...............................................2-24
Head Cleaning ............................................2-25
About head cleaning ..................................2-25
Perform head cleaning depending
on the test printing result ...........................2-25
Set the media feeding .................................2-26
Setting Feed Correction .............................2-26
Checking the media feeding amount
deviation during printing ..............................2-28
Setting Feed Check Pattern .......................2-28
Aligning the Print Result Lengths ................2-30
Setting Feed Check Pattern .......................2-30
Correct the ink drop position for
bidirectional printing ....................................2-32
Printing Data ...............................................2-34
Starting a Printing Operation .....................2-34
Stopping a printing operation halfway ........2-35
Deleting Received Data (Data Clear) ........2-35
Using method of weight for assistant roller .2-36
Chapter 2
Basic Operations