2-82
Figure 41 Structural diagram of the active AGSS gas reservoir assembly
The passive AGSS gas reservoir assembly consists of three parts: AGSS inlet gas reservoir,
AGSS pump box, and AGSS passive plug. The AGSS pump box is connected to the pneumatic
block through a silicone tube. After the waste gas enters the gas reservoir, it is pumped to the
AGSS pneumatic block assembly under the action of the gas reservoir and then directly
exhausted to air. The structural diagram of the passive AGSS gas reservoir assembly is shown
below.
Figure 42 Structural diagram of the passive AGSS gas reservoir assembly
To Next Page
Loading...
