Mindray Accutorr 7 - Selecting a Network Type; Setting the Wired Network; Setting the Wireless Network (Optional)

14 - 2 Accutorr 7 Operator’s Manual
14.1.1 Selecting a Network Type
The equipment supports both wired and wireless (optional) networking. To set the
network type,
1. Select [Main] → [Maintenance >>] → [User Settings >>] → Enter the required
password → Select [Ok] to access the [User Settings] menu.
2. Select [Network>>] → [Monitor Network Setup >>] to access the [Monitor
Network Setup] menu.
3. Set [Network Type] to [LAN] or [WLAN].
14.1.2 Setting the Wired Network
To set the wired network, follow this procedure:
1. Select [Main] → [Maintenance>>] → [User Settings >>] → enter the required
password → Select [Ok] to access the [User Settings] menu.
2. Select [Network >>] → [Monitor Network Setup >>] to access the Monitor
Network Setup menu.
3. Set the [Network Type] to [LAN].
4. Set the [Address Type] to [DHCP] or [Manual].
◆ If [Address Type] is set to [DHCP], the monitor can automatically acquire
network parameters.
◆ If [Address Type] is set to [Manual], you need to manually input the
monitor IP address, subnet mask and gateway address.
5. Click [Ok] to confirm the setting.
14.1.3 Setting the Wireless Network (Optional)
The monitor can be connected to a wireless network via a built-in Wi-Fi module. To set
the wireless network:
1. Select [Main] → [Maintenance>>] → [User Settings >>] → enter the required
password → Select [Ok] to access the [User Settings] menu.
2. Select [Network >>] → [Monitor Network Setup >>] to access the Monitor
Network Setup menu.
3. Set the [Network Type] to [WLAN].
4. Set the [Address Type] to [DHCP] or [Manual].
◆ If [Address Type] is set to [DHCP], the monitor can automatically acquire
network parameters.
◆ If [Address Type] is set to [Manual], you need to manually input the
monitor IP address, subnet mask and gateway address.
5. Select [WLAN Setup >>] to access the WLAN setup menu.