Mindray Accutorr 7 Operator's Manual

Accutorr 7 Operator’s Manual D - 5
D.2.2 SpO
2
Alarm Messages
Alarm Message Clearable?
(Yes/No)
Alarm
Level
Cause Solution
SpO
2
Sensor Off
(Masimo, Nellcor)
Yes Low*(
Monito
r
mode)
Off*
(Spot
Check
mode)
The SpO
2
sensor has
become detached
from the patient or
the module, or there
is a fault with the
SpO
2
sensor, or an
unspecified SpO
2
sensor has been
used.
Check the sensor
application site and
the sensor type, and
make sure if the
sensor is damaged.
Reconnect the
sensor or use a new
sensor.
SpO
2
Sensor
Fault
(Masimo)
No Low
SpO
2
No Sensor
(Masimo, Nellcor)
Yes Low
SpO
2
Unknown
Sensor (Masimo)
No Low
SpO
2
Too Much
Light (Masimo)
No Low There is too much
light on the SpO
2
sensor.
Move the sensor to
a place with lower
level of ambient
light or cover the
sensor to minimize
the ambient light.
SpO
2
No Pulse
(Nellcor)
No Low SpO
2
sensor failed
to obtain pulse
signal.
Move the sensor to
a site with better
perfusion.
SpO
2
Comm Stop
(Masimo, Nellcor)
No High An error occurred to
the SpO
2
module, or
there is a problem
with the
communications
between the
module and the
monitor.
Restart the monitor.
If the error remains,
contact Mindray or
your service
personnel.
SpO
2
Comm
Abnormal
(Masimo, Nellcor)
Yes High
SpO
2
Init Err Yes High
SpO
2
Board Fault
(Masimo)
No Low There is a problem
with the SpO
2
measurement
board.
Do not use the
module and contact
Mindray or your
service personnel.

Mindray Accutorr 7 Specifications

General

Brand	Mindray
Model	Accutorr 7
Category	Medical Equipment
Language	English