Accutorr 7 Operator’s Manual 2 - 3
6. Power ON/OFF switch
◆ Press this key to turn the monitor on.
◆ If no parameter is being measured, press this key to enter Standby mode.
◆ When the monitor is on, press and hold this key for more than 2 seconds to
turn the monitor off.
An indicator is built into this switch. It turns on when the monitor is on and turns
off when the monitor is off.
7. Battery indicator
◆ On: indicates that the battery is installed and the AC power is connected.
◆ Off: indicates that no battery is installed when AC power is connected, or
indicates that the battery is installed, but no AC power is connected when
the monitor is powered off.
◆ Flashing: indicates that the monitor is powered by battery.
8. Alarm Reset key
◆ Press this key to disable the audio of present alarms.
◆ Press and hold this key for more than 2 seconds to pause or restore alarms.
9. NIBP Start/Stop key
◆ Press to start or stop NIBP measurements.
10. Admit patient key
◆ Press this key to admit a new patient.
◆ Press this key to return to the main screen.
11. Knob
◆ Rotate the knob clockwise or counterclockwise to move the cursor.
◆ Press the knob to select one item, such as accessing a menu or confirming
the selection.
To Next Page
Loading...
Need help?
General
