9.4.1.2 Loading the software on your notebook/PC
1. Click the relevant le in the "Explorer" with the mouse and drag it into the [Select]
window, (or use 'Copy and paste').
2. Under [COM-Port] select "Network" and enter the devices IP addresses.
3. Click [Flash] to start the procedure.
The rst three LEDs blink in a pattern on the device for 30 seconds.
4. Press the reset key (1) on the device a short time, within these 30 seconds using a pen
tip or paper clip with a diameter of 1.0mm.
Transmitter Series PR 5220 9 Extended functions
Minebea Intec EN-184
To Next Page
Loading...
Need help?
General
