Minicom Smart 108 IP User Manual

In Manager IP Address
, type the static IP address of the Centralized Management
Manager.
Although not required, it is
if the
Smart 108/116 IP
Centralized Management Manager
3.4
Configuring Network SNMP Settings
You can activate SNMP logging
the Smart 108/116 IP
to send monitoring events (such as log entries) to the SNMP
server. See Chapter 9
for a list of all recorded SNMP events.
To enable
and configure
1.
From the configuration menu, select
The SNMP page
opens.
2. Select the
Enable Traps
and operation.
3. In Community,
type the
4. In SNMP Manager IP
, type the SNMP Server IP address.
3.5 Configur
ing User Settings
An Administrator can
add, edit, remove
There are two levels of user access:
 Administrator –
has unrestricted access to all windows and settings, and can
change the name and password of all users
 User – can access
and
settings and power cycle
3.5.1 Adding a User
To add a User:
1.
From the configuration menu, select
Configuring
Configuring
Network SNMP Settings
, type the static IP address of the Centralized Management
Although not required, it is
recommended to type the
Manager IP Address
Smart 108/116 IP
resides on the same network segment
as the
Centralized Management Manager
.
Configuring Network SNMP Settings
You can activate SNMP logging
to provide support network monitoring. This will cause
to send monitoring events (such as log entries) to the SNMP
for a list of all recorded SNMP events.
and configure
SNMP logging:
From the configuration menu, select
SNMP.
opens.
Figure 15 – SNMP Settings
Enable Traps
checkbox to enable SNMP traps of
Smart 108/116 IP
type the
name of the SNMP community.
, type the SNMP Server IP address.
ing User Settings
add, edit, remove
, and block Users.
There are two levels of user access:
has unrestricted access to all windows and settings, and can
change the name and password of all users
and
control target s
ervers, but cannot use advanced mouse
settings and power cycle
; cannot access the
Web configuration interface
From the configuration menu, select
Users.
Configuring
the Network
Network SNMP Settings
User Guide | 29
, type the static IP address of the Centralized Management
Manager IP Address
even
as the
to provide support network monitoring. This will cause
to send monitoring events (such as log entries) to the SNMP
Smart 108/116 IP
events
has unrestricted access to all windows and settings, and can
ervers, but cannot use advanced mouse
Web configuration interface

Minicom Smart 108 IP Specifications

General

Brand	Minicom
Model	Smart 108 IP
Category	Switch
Language	English