Minicom Smart 108 IP User Manual

Troubleshooting – Safe Mode
Restoring Factory Defaults
58 | Smart 108/116 IP
To enter Safe mode:
1. While powering up
Smart
the back panel
of the unit
The device boots up in S
a
2.
Wait until the unit finishes booting (
3. Determine
the IP address of the
whether or not
there is a DHCP server on the network. If there is, the DHCP server
assigns an IP address to the
unit boots with the static IP address 192.168.2.155.
4.
Open Internet Explorer and type into the Address box:
(Do not start the address
The Login page appears.
5. In User, type username
admin
(This username and pas
s
A menu appears.
5.2
Restoring Factory Defaults
You can restore all
Smart 108/116 IP
Smart
108/116 IP, press and hold down the
Go Local
of the unit
for three to four seconds.
a
fe mode.
Wait until the unit finishes booting (
one to two minutes).
the IP address of the
Smart 108/116 IP unit
. The IP address depends on
there is a DHCP server on the network. If there is, the DHCP server
assigns an IP address to the
Smart 108/116 IP unit. I
f there is no DHCP server, the
unit boots with the static IP address 192.168.2.155.
Open Internet Explorer and type into the Address box:
http://IP
address/config
(Do not start the address
with https.)
Figure 46 – Login Page
admin
, and in Password, type SAFEmode (ca
se
s
word works only in Safe mode.)
Figure 47 – Safe Mode Menu
Restoring Factory Defaults
Smart 108/116 IP
settings to their default values.
Go Local
button on
. The IP address depends on
there is a DHCP server on the network. If there is, the DHCP server
f there is no DHCP server, the
address/config
.
se
sensitive).

Minicom Smart 108 IP Specifications

General

Brand	Minicom
Model	Smart 108 IP
Category	Switch
Language	English