Minicom Smart 108 IP User Manual

2. Press Options -
> Advanced
3.
Open the appropriate hex file.
4. Click Start.
The firmware updates.
6.3.9
Restoring Factory Settings
You can restore the OSD to the factory settings from the Update software.
All changes made (
removed.
To restore the OSD factory settings:
1. Select
Options/Advanced/Set default
The OSD returns to the factory default settings.
You can also restore the OSD
6.4
Troubleshooting
This section
describes how to troubleshoot the following two problems that may arise
when updating the
Smart 108/116 IP firmware:

Communication Error message
 Electricity failure
6.4.1
Communication Error
When updating a unit,
a Communication Error message
To
fix the communication problem
1. C
heck that the RS232 Serial cable’s RS232 connector is connected to the
Flash port.
2.
Check that the RS232 Serial cable’s DB9F connector is connected to the laptop’s
Serial port.
3. Verify that
there is no Remote session in progress by pressing the
4.
Restart the update process.
6.4.2
Electricity Failure
The electricity may
fail while updating the Smart 108/116 IP firmware
Operating
the Smart 108/116 IP Switching System Locally
Troubleshooting
> Advanced
-> Manual Update.
Open the appropriate hex file.
The firmware updates.
Restoring Factory Settings
You can restore the OSD to the factory settings from the Update software.
All changes made (
such as passwords, access rights, and
names) will be
To restore the OSD factory settings:
Options/Advanced/Set default
.
The OSD returns to the factory default settings.
You can also restore the OSD
default settings
from the OSD (F7)
Troubleshooting
– Update Software
describes how to troubleshoot the following two problems that may arise
Smart 108/116 IP firmware:
Communication Error message
Communication Error
Message
a Communication Error message
may appear.
fix the communication problem
:
heck that the RS232 Serial cable’s RS232 connector is connected to the
Check that the RS232 Serial cable’s DB9F connector is connected to the laptop’s
there is no Remote session in progress by pressing the
Local
Restart the update process.
Electricity Failure
fail while updating the Smart 108/116 IP firmware
.
the Smart 108/116 IP Switching System Locally
Troubleshooting
– Update Software
User Guide | 79
You can restore the OSD to the factory settings from the Update software.
names) will be
from the OSD (F7)
(see page 66)
describes how to troubleshoot the following two problems that may arise
heck that the RS232 Serial cable’s RS232 connector is connected to the
switch’s
Check that the RS232 Serial cable’s DB9F connector is connected to the laptop’s
Local
button.
.

Minicom Smart 108 IP Specifications

General

Brand	Minicom
Model	Smart 108 IP
Category	Switch
Language	English