Code Choice Mode Name Description
Multi-
Copy
Key
Setting (
∗
: Initial Setting)
C7
50K Stop Mode Selects whether or not to
inhibit copying when a
toner-empty condition is
detected after the IU
Counter has counted 50,000.
0 Disables 50K stop.
∗
Inch Areas
1 Enables 50K stop.
∗
Metric
Areas
C15
Toner Empty Stop
Mode
Selects whether or not to
inhibit copying when the
toner-to-carrier ratio
becomes 2% or lower after
a toner-empty condition has
been detected.
0 Does not inhibit copying.
∗
1 Inhibits copying.
C20
Leading Edge
Erase Mode
Varies the width of erase on
the leading edge.
(in 3-mm increments)
0 Makes the leading edge erase
width smaller.
1 Makes the leading edge erase
width greater.
∗
C21
Trailing Edge
Erase Mode
Selects whether or not to
erase the trailing edge.
(in 3-mm increments)
0 Trailing edge not erased.
1 Trailing edge erased.
∗
C23
Loop Length
Adjustment Mode
Adjusts the length of the
loop to be formed in paper
before the Synchronizing
Rollers.
See p. 12.
C31
1-Sided Original
Stop Position
Adjustment Mode
Adjusts the position to stop
the 1-sided original when
the Automatic/Duplexing
Document Feeder is used.
See p. 12.
C32
2-Sided Original
Stop Position
Adjustment Mode
Adjusts the position to stop
the 2-sided original when
the Automatic/Duplexing
Document Feeder is used.
See p. 12.
C33
2-in-1 Original Stop
Position
Adjustment Mode
Adjusts the position to stop
the original for 2-in-1
copying when the
Automatic/Duplexing
Document Feeder is used.
See p. 12.
C34
2-in-1 Original
Distance
Adjustment Mode
Adjusts the distance
between the originals for
2-in-1 copying when the
Automatic/Duplexing
Document Feeder is used.
See p. 12.
C90
ATDC Detection
Level Mode
Sets the level at which the
ATDC Sensor functions to
maintain a target
toner-to-carrier ratio of the
developer.
See p. 12.
S-9
To Next Page
Loading...
