Minolta EP1080 - Page 204

NOTES:
•
When the PM Counter Mode (C-5) has been set to 0 or 1 and when the Maintenance Call
Reminder ON/OFF Mode (C-4) has been set to 1, the IU Service Life Indicator lights up when
the Counter counts down to zero. (At this time, a copy cycle can still be initiated.)
•
When the PM Counter Mode (C-5) has been set to 2 or the 50K Stop Mode (C-7) has been set
to 1, the IU Service Life Indicator lights up when the Counter counts to a given number
regardless of the setting made for the Maintenance Call Reminder ON/OFF Mode (C-4). (At
this time, a copy cycle cannot be initiated.)
•
If the 50k Stop Mode (C-5) has been set to 1, the IU Service Life Indicator starts blinking
during a copy cycle at 47.5K for Metric Areas and 49K for Inch Areas, and lights up steadily at
55K or when a toner-empty condition is detected. (At this time, a copy cycle cannot be
initiated.)
Setting Procedure
(1) With the copier in the state ready to enter a particular Tech. Rep. Mode, press "2" to set the
copier into the Tech. Rep. Choice Mode.
(2) Using the appropriate Multi-Copy Key, enter the Choice code number.
(3) Press the Start Key to validate the Choice Mode selected. Then, the Choice code appears on
the Magnification Ratio Indicator and the current setting appears on the Multi-Copy Display.
Changing the Setting
(1) Obtain the Choice code, for which you wish to change the setting, on the Magnification Ratio
Indicator.
(2) Press the Clear Key to clear the current setting.
(3) Press the Multi-Copy Key number which corresponds to the choice setting you wish to select.
(4) Press the Start Key to validate the new setting. (If the choice setting is illegal, i.e., if any
number that is not available is entered, the setting is not updated and the number blinks on
the Multi-Copy Display.)
S-10