Mitsubishi Electric MELSEC iQ-R16MTCPU - Page 20

18
■Machine No. representation
In the positioning dedicated signals, "m" in "M43904+32m", etc. indicates a value corresponding to machine No. as shown in
the following table.
• Calculate as follows for the device No. corresponding to each machine.
Ex.
For machine No.8 in MELSEC iQ-R Motion device assignment
M43904+32m ([St.2120] Machine error detection) M43904+327=M44128
D53168+128m ([Md.2020] Machine type)=M53168+287=D54064
■Line No. representation in G-code control
In the positioning dedicated signals, "s" in "D54496+128s", etc. indicates a value corresponding to line No. as shown in the
following table.
• Calculate as follows for the device No. corresponding to each line.
Ex.
For line No.2 in MELSEC iQ-R Motion device assignment
D54440.0+4s ([St.3208] During G-code control)=D54440.0+41=D54444.0
D54496+128s ([Md.3016] Number of axes on line)=D54496+1281=D54624
■Line No. and axis No. representation in G-code control
In the positioning dedicated signals, "sn" in "D54278+16sn", etc. indicates a value corresponding to line No. and axis No. as
shown in the following table.
• Calculate as follows for the device No. corresponding to each line.
Ex.
For line No.2, axis No. 8 in MELSEC iQ-R Motion device assignment
D54448.0+2sn ([St.3076] Smoothing zero)=D54448.0+215=D54478.0
D54754+32sn ([Md.3146] Rotating axis setting status)=D54754+3215=D55234
Machine No. m Machine No. m
1054
2165
3276
4387
Line No. s
10
21
Line No. Axis No. sn Line No. Axis No. sn
110 218
21 29
32 310
43 411
54 512
65 613
76 714
87 815