APPENDICES
Appendix 2 Event List
425
A
*1 For home position return request ON by a servo amplifier connection in an incremental system, the information for several axes is
recorded in one record when SSCNET(/H) is established.
*2 When the disconnection of several axes in the same operation cycle is detected, all disconnected axes are recorded in one record.
(Disconnected axis information can be checked as detailed information.)
*3 When project data is written with "CPU write" in MT Developer2, separate file names are not recorded.
*4 After installation, the operating system software is recorded when started up in normal mode. When the operating system software
before change does not support this event, the operating system software version before change is not displayed correctly.
20100 Operation Information Error clear Error clear was performed. Operation
source
information
Operation target
information
20200 Event history clear The event history was cleared.
20300 SD memory card
enabled
The SD memory card was enabled.
20301 SD memory card
forced disabled
The SD memory card forced disable
function was performed and the SD
memory card is ready for removal.
27FFC Parameter change Switch the parameter file according
to parameter switching function.
Parameter
change
information
Drive and file
information
27FFD Write transient
command
Transient command transmission
(write) executes to servo amplifier.
Transient
command
information
27FFE Write project
*3
Wrote project data. Operation
source
information
Drive and file
information
27FFF Operating system
change
*4
Changed the operating system. Operating
system version
information
Event
code
Event
type
Event
category
Detected event Description Detailed information
Detailed
information 1
Detailed
information 2
Detailed
information 3
To Next Page
Loading...
