Mocon AMETEK Dansensor Lippke 5000 - Access Levels

98 User Guide EN Dansensor® Lippke® 5000
P/N 380419-C
05/2022
Access levels
The various access levels and the associated rights are described below:
NOTE! A higher level of access always has all rights from lower access levels.
Standard Test
Operator
Basic user.
 Can only perform tests on workflows/test definitions marked as
Standard Test.

If Use State Mark is enabled in Settings -> Device the access
is limited to Standard Test test definitions/workflows marked with
State = Current.
 Cannot change any settings.
Operator Normal user.
 Can perform tests using all test definitions/workflows with
State = Current.
 Cannot change any settings.
Supervisor Daily administrator of test definitions/workflows and standard users.
 Has access to all test definitions/workflows.
 Can create test definitions/workflows and edit custom fields.
 Can create Standard Test Operator and Operator users, but not
other Supervisor users.
 Can access the System Leak Test function from the Service ->
Test & Adjustment menu.
 Can export measurement logs and error/event logs.
 Cannot change settings in the Settings menu.
Administrator Device administrator.
 Can change settings in the Settings menu (except for the
Service menu).
 Can create Supervisor users and other Administrator users.
 Can reset PIN-codes.
 Can remove access to Service login.
 Can export and import all data.
Service Service Technician.
 Can access all settings in the Settings -> Service menu.
 Can access all functions in the Service -> Test & Adjustment
menu.