Dansensor® Lippke® 5000 EN User Guide 83
P/N 380419-C
05/2022
5. Cleaning and Maintenance
General
NOTE! Performing cleaning and maintenance regularly reduces the chances of
equipment failure.
CAUTION! Personnel performing any maintenance or cleaning must familiarize
themselves with the "Safety and Handling Instructions" on page 129 before
attempting any of these procedures.
The Dansensor® Lippke® 5000 devices are maintenance-free. This particularly applies to the
pneumatics and electronic control systems.
Cleaning and maintenance of other items such as measurement accessories and needles etc.
is described in the following.
Parts required for maintenance purposes are listed in "Consumables, accessories and options"
on page 127.
Cleaning
Device and accessories
All device and test accessory surfaces should be cleaned using a mild soap solution and a
wrung cloth.
Needles and test heads
Disassemble needles and test heads from time to time and check whether they are
completely clean and that all openings are free from dirt and residues. Any residues can be
removed carefully by means of a needle and liquids should be blown out using compressed
air.
Flushing with water and alcohol is also possible. After that, all parts should be blown out
thoroughly with compressed air to make sure that no liquids remain.
Hoses
All hoses should be disconnected regularly and blown through using compressed air.
NOTE! When using compressed air for cleaning, make sure that air is dry and oil
free.
To Next Page
Loading...