Dansensor® Lippke® 5000 EN User Guide 73
P/N 380419-C
05/2022
Get started
When you start the device for the first time and before you start making measurements, it is
recommended that you perform some basic device settings.
NOTE! To be able to change device settings you must change the device to
“Administrator” access level.
To do so select “Access” from the “Main Menu” - see "Access" on page 97 for details.
Device Settings
Go through the parameters available in the Settings menu and make appropriate
settings - see "Settings" on page 115 for details.
Set up Users
From the factory no default users have been created, but we highly recommend that you
create specific users, so that you can separate measurements performed by different users
later on for use in statistics etc. - see
"Access" on page 97 and "Login" on page 120 for details.
Set up Test Definitions and Workflows
From the factory no default Test Definitions have been created, but we highly recommend
that you create specific Test Definitions, so that you can separate the different tests later on
for use in statistics etc. - see
"Workflow" on page 88 for details.
To Next Page
Loading...
