130 User Guide EN Dansensor® Lippke® 5000
P/N 380419-C
05/2022
Repairing
Don’t open the device and do not attempt to repair it yourself, as this may damage it or
may cause injury to you.
If device is damaged, malfunctions, or comes in contact with liquid, contact your
authorized MOCON Dansensor service provider.
Cables
If using other third-party cables and power plugs, make sure that they are compatible with
USB 2.0 or later, and that the power supply and plugs are compliant with applicable
country regulations.
Replace damaged cables immediately. Using damaged cables can cause fire, electric shock,
injury, or damage to the device or other property.
Explosive atmospheres
Using the device in any area with a potentially explosive atmosphere, such as areas where
the air contains high levels of flammable chemicals, vapours, or particles, may be
hazardous. Obey all signs and instructions.
Cleaning
Never use hard tools or abrasive materials when cleaning any part of the device.
Never use cleaning agents containing chlorinated solvents or acetic or phosphoric acid.
These constitute a health hazard and could damage the device.
Avoid getting moisture in openings.
When using compressed air for cleaning of e.g. hoses or needles, use safety goggles and
make sure that items have been disconnected from the device.
Using connectors, ports, and buttons
Never force a connector into a port or apply excessive pressure to a button, because this
may cause damage that is not covered under the warranty.
If the connector and port don’t join with reasonable ease, they probably don’t match.
Check for obstructions and make sure that the connector matches the port and that you
have positioned the connector correctly in relation to the port.
To Next Page
