PARISON CONTROLLER
moog
Moog Italiana srl - Bergamo MAN145-UM-D01A-EN 51
4.3 Machine Setup.
Figure 42
Machine Setup: Configure the machine.
Access: From Main Menu 2 with key F7.
Use: Configure the PARISON CONTROLLER according to the typology of the machine that will be
connected.
ATTENTION: to modify some parameters the digital input number 13 (machine in
automatic mode) has to be OFF. This operation is permitted only if the machine is in
manual mode.
4.3.1 Function of the machine.
It is possible to select one of the following
types of machine (in manual mode):
Continuous extrusion to independent
profile.
Continuous extrusion to unique profile.
With accumulator position.
With time accumulator.
To Next Page
Loading...
Need help?
General
