Motion Control Engineering Nidec iControl - Page 450

Index-11
empty car tests 3-13
run testing 3-11, 3-12
Pre-Run Status test point, description 9-5
Pre-start Door Lock Fault message 6-60
Pre-Start Sequence 4-35–4-40
diagrams 4-36
parameters 4-35
Pretorque (Raw) test point, description 9-5
Pretorque Command test point, description 9-5
Pretorque Gain, adjusting 4-17
Pretorque option 4-17
Pretorque Position Compensation 4-17
PRI FIRE SWITCH BYP message 6-60
PRI FIRE SWITCH ON message 6-60
Primary Fire Switch Bypass message 6-60
Primary Fire Switch On message 6-60
Printing screens in iView 8-38
Q
QPRAM Device Error message 6-60
Quadrature Pulse Sequence 3-10
Quadrature Pulse Voltages 3-10
R
R DPM OPEN-GS CLOSED message 6-62
R DR CLS FLT REC FAIL message 6-61
R6 Regenerative AC drive parameters 9-44
RB resistor, adjusting 2-9
REAR DOB BYPASSED message 6-61
Rear Door Board Quick Reference 6-101
REAR DOOR CLOSE FAULT message 6-60
Rear Door Close Fault message 6-60
Rear Door Close Fault Recovery Failure message 6-61
Rear Door Close Time-out message 6-61
Rear Door Contact Fault message 6-61
REAR DOOR CONTCT FLT message 6-61
Rear Door Open Button Bypassed message 6-61
Rear Door Open Fault message 6-62
Rear Door Open Time-out message 6-62
REAR DOORS STOPPED message 6-61, 6-62
Rear Doors Stopped message 6-61, 6-62
Rear DPM Open - GS Closed message 6-62
REAR HALL DOB BYP message 6-62
Rear Hall Door Open Button Bypassed message 6-62
REAR PHOTO EYE BYP message 6-62
Rear Photo Eye Bypassed message 6-62
REAR PHOTO EYE FAIL message 6-63
Rear Photo Eye Failure message 6-63
REAR SAFE EDGE BYP message 6-63
Rear Safe Edge Bypassed message 6-63
REAR SAFE EDGE FAIL message 6-63
Rear Safe Edge Failure message 6-63
Receive Sys Params message 6-63
Register a car call 4-4
Relay Board Quick Reference 6-98
Relay output selection 5-35, 6-105, 6-115
Relevel, iBox status LED 7-10
Relevel, verifying 4-5
Releveling 4-28
Reset EQ board 3-6
Reset Rope Gripper 2-13
resizing windows in iView 8-34
RESTRICTED message 6-64
Restricted message 6-64
RET CAM PROTECTIN FLT message 6-64
RETIRING CAM DLK FLT message 6-64
Retiring Cam Door Lock Fault Activated message 6-64
Retiring Cam Door Lock Fault Deactivated message 6-64
Retiring Cam Door Lock Fault message 6-64
Retiring Cam Protection Fault Activated message 6-64
Retiring Cam Protection Fault Deactivated message 6-64
Retiring Cam Protection Fault message 6-64
RFI, Radio Frequency Radiation 2-3
RFI/EMI noise, reducing 2-9
Ride quality, adjusting 4-29
Ring and String circuit 3-6
Rollback adjustment, Speed pick delay 4-6
Rollback, controlling 4-16
Rope Gripper 2-13
Rope Gripper Board Quick Reference 6-107
Rope Gripper Bypass 2-13
Rope Gripper Reset 2-13
Rope Gripper Wiring 2-13
Rope Stretch Releveling 4-28
Rope Tension Load Weigher 4-30
Rough Acceleration or Deceleration 4-15
Run testing, preparing for final adjustments 3-12
Run the motor 2-30, 9-69
Run, iBox status LED 7-10
RX-, Cartop Link input 6-110, 9-7
RX+, Cartop Link input 6-110, 9-7
S
Sabbath Operation Activated message 6-64
Sabbath Operation Deactivated message 6-64
Sabbath Operation, SABBATH OPERATION message 6-64
SAFC, Safety Cartop input 9-11
Safety 3-9
Safety A Contract Overspeed Fault message 6-64
Safety A IMP Configuration Mismatch message 6-65
Safety A Inspection Leveling Overspeed Fault message 6-65
Safety A Inspection Overspeed Fault message 6-65
Safety A SIB Device Fault message 6-65
Safety A SIB Device Fault Off message 6-65
Safety A UETS Level 2 Speed Fault message 6-65
Safety A Unintended Motion Fault message 6-65, 6-67
Safety A, iBox status LED 7-10
Safety B Contract Overspeed Fault message 6-65
Safety B DETS Level 2 Speed Fault message 6-66
Safety B Fault Activated message 6-66
Safety B Fault Bypass Switch Timed Out message 6-66
Safety B Fault Deactivated message 6-66
SAFETY B FAULT message 6-66
Safety B Inspection Leveling Overspeed Fault message 6-66
Safety B Inspection Overspeed Fault 6-66
Safety B Safety Bypass Jumper Timed Out message 6-66
Safety B SIB Device Fault message 6-66
Safety B SIB Device Fault Off message 6-66
Safety B UETS Level 2 Speed Fault message 6-67
Safety B, iBox status LED 7-10