6802800U74-AN
Chapter 6: Configuration and Testing
2 In the command line, type reset and confirm if necessary.
3 Interrupt the reboot procedure with the ESCAPE key.
4 Log on to BOOT1 mode.
The BOOT1 mode prompt appears. For a Site Controller, it is:
SC#
and in the case of Base Radio it is:
boot1>
Postrequisites: To return to the default Base Radio application or the Site Controller application, type
reset -oplatform.
6.2.1.4
Logging on to the Base Radio Core Mode
Base Radio Core is the second stage bootloader in the BR-Arch-2 architecture. Use this mode to start
other applications (for example the Test Application), and set the basic Base Radio configuration.
Procedure:
1 Log on to the Base Radio application. See Logging on to the Base Radio Application through
Serial Connection on page 224.
2 In the command line, type reset and confirm if necessary.
3 Interrupt the reboot procedure with the ESCAPE key.
4 Log on to Base Radio Core mode.
The Base Radio Core mode prompt appears:
Core)
6.2.1.5
Logging on to the Test Application
Procedure:
1 Log on to the Site Controller or Base Radio mode appropriate for your architecture:
• If you want to log on to the Test Application on Site Controller or Base Radio in BR-Arch-1
architecture, see Logging on to the BOOT1 mode on page 224.
• If you want to log on to the Test Application on Base Radio in BR-Arch-2 architecture, see
Logging on to the Base Radio Core Mode on page 225.
2 In the command line, start the Test Application by performing one of the following actions:
If you want to log on to the Test Applica-
tion in the BR-Arch-1 architecture,
perform the following actions:
a In the command line enter the command:
testapp
b Log on with the command login -u<X>
where <X> is the user name you want to
use.
c At the prompt, enter the password.