6802800U74-AN
Chapter 6: Configuration and Testing
• cpp -olan2 -i<IP>
where <IP> is the new IP address, for example 10.0.253.11.
IMPORTANT: Do NOT change the original MAC addresses of the Base Radio.
6.5.2.2
Enabling Base Radio Receiver Branches
Every new Base Radio requires enabling receivers. It is possible to separately enable or disable every
branch.
Procedure:
1 Log on to the Base Radio in application mode. See Logging on to the Base Radio Application
through Serial Connection on page 224.
2 Verify if there are any existing settings present. Enter the following command: get nvm_param
rx1 rx_fru_config and press ENTER.
The branch setting depends on the receiver diversity required for the site.
3 If the Base Radio Application does not return any values, or returns an incorrect setting, fix the
parameter by entering the following command: set nvm_param rx1 rx_fru_config <X>
where <X> is a number corresponding to one of the following settings:
• 1 - Receiver branch 1 enabled
• 2 - Receiver branch 2 enabled
• 3 - Receiver branches 1, and 2 enabled
• 4 - Receiver branch 3 enabled
• 5 - Receiver branches 1, and 3 enabled
• 6 - Receiver branches 2, and 3 enabled
• 7 - Receiver branches 1, 2, and 3 enabled
6.5.2.3
Additional Receiver Configuration for BR-Arch-1
The receivers in BR-Arch-1 Base Radios might require additional parameter modification. The
procedures in this section are applicable only to Base Radios in BR-Arch-1 architecture. Do not
perform these actions in BR-Arch-2 architecture.
6.5.2.3.1
Verifying the Base Radio Receiver Parameters in BR-Arch-1 Architecture
The procedure below can be done locally as well as remotely. The commands to check and change
the BR parameters require the use of BRC Application MMI. Receivers in BR-Arch-2 do not require
reconfiguring.
Procedure:
1 Log on to the Base Radio in application mode. See Logging on to the Base Radio Application
through Serial Connection on page 224.
2 Enter:
To Next Page
Loading...
Need help?
General
