6802800U74-AN
Chapter 6: Configuration and Testing
Figure 132: BRC Indicators
6.5.2
Base Radio Position and Receivers Selection
The new Base Radio needs to be assigned a position identifier. This operation is performed from the
Service port.
Use the MMI commands to:
• Set the position identifier of the Base Radio within the cabinet. See Setting and Accessing Base
Radio Position by Using the cccp Command on page 237.
• Set the number of active receivers (diversity) of the new Base Radio. See Enabling Base Radio
Receiver Branches on page 239.
• BR-Arch-1 Base Radios only: Verify and configure additional receiver parameters. See Additional
Receiver Configuration for BR-Arch-1 on page 239.
For detailed information on the MMI commands, see the MTS Man Machine Interface Commands
Manual.
Reset
TX
AUX
Status
BR
Alarm
To Next Page
Loading...
Need help?
General
