MUTOH valuejet 1614 - Page 56

Users Guide ValueJet 1614
56 AP-75790  Rev 1.4 -22/02/2011,
Step 10 : Perform the Confirm Print.
Press the [+] key or [] key to select "PF3: Confirm Print".
Press the [Enter] key on the operation panel.
The operation panel displays "Feed Length: 250 mm".
Notes
The length that the media is fed (feeding length) for confirmation adjustment printing is normally set at
250 mm.
If you make the feeding length longer, the accuracy of the Media feed compensation improves.
If you want to change the feeding length, press the [+] key or [] key and change the set value.
Press the [Enter] key on the operation panel.
± The operation panel displays "Printing".
± Start Confirmation adjustment printing.
î
ïï
N° Name
1 Feed length
2 Media feeding direction
After the confirmation adjustment printing, cut the media. For more information, please refer to: 
Cutting media
Step 11 : Measure the distance between two pluses in the confirmation adjustment print using a
measurement tool, such as a ruler, confirm that the distance matches the feeding length when
printing.
If the distance does not match the feeding length, follow the procedure from 1 to 5 and re-adjust.