1. Installing / Removing Internal Options
1.5 Confirming Servers (UID Switch)
Using UID (Unit ID) Switch helps you to identify the target server.
You can turn on or off UID LED in either of following two ways:
(1) Press the UID switch on web console.
If the location of target server is unknown, press the UID button of the target server to blink the
UID LEDs on the target server (front and rear). Press it again to turn off the LEDs.
(2) Press the UID switch on server.
When the location of target server is known and you need to work with the server from rear side,
press the UID switch on front panel. The UID LEDs on front and rear panel go on. You can
identify the target server by viewing the LED on rear panel. Similarly, press the UID switch on
rear panel to identify the target server by viewing the UID LED on front panel when working with
the server from front side. Press the UID switch again to turn off the LEDs.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
163
To Next Page
Loading...