NEC express5800 A2010b - Configuring Using BMC Configuration in Off-Line TOOL of BIOS

5. EXPRESSSCOPE Engine SP3
Chapter 3 Setup
5.5.3
Configuring using BMC Configuration in Off-line TOOL of BIOS
Take the steps below to configure network using BMC Configuration of Off-line TOOL.
1. Run POST according to Chapter 3 (3.1.1 POST Flow). After the logo display, the following message
appears on screen.
Press <F2> SETUP, <F4> ROM Utility
2. If you press the <F4> key, the following message appears. Upon completion of POST, the Off-line TOOL
is launched. Pressing the <F4> key while the logo is on the screen also displays the BMC Configuration
menu screen.
Entering ROM Utility . . .
3. Select a keyboard type on Keyboard type selection menu. The BMC Configuration menu of Off-line
TOOL is displayed. Use this menu to configure network for EXPRESSSCOPE Engine SP3.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
269