NEC express5800 A2010b - Component Status

7. Using Remote Management
Chapter 3 Setup
7.9.2
Component Status
(1)
Fault Information
Overview
Use this page to view status of hardware components belonging to the server, or clear fault information.
Administrator privilege is required to clear the fault information.
• Click the [Maintenance] tab to display available menus.
• Select [Fault Information] from menu tree in left pane.
Buttons
① [Clear All Faults] button
Press the [Clear All Faults] button to clear fault status of hardware component and change status to normal
value. Administrator privilege is required to use this feature.
② [Reload] button
Press the [Reload] button to display the latest information.
Important
If fault information on management board #1 is cleared by Clear All Faults
while the
master BMC is running on management board #2, a failover occurs. At thi
s time,
communication between master and standby BMC is disconnected. So the care
must be taken.


Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
387