1. Installing / Removing Internal Options
1.8.2
Removal
Take the steps below to remove hard disk drive.
If you transfer or dispose of the removed hard disk drive, refer to Chapter 1 (1. Transfer, Movement, and
Disposal) in “Maintenance Guide” to erase data.
NEC assumes no liability for data leakage should the product be transferred to a
third party without erasing the data.
If you need to remove a disk due to a hard disk drive failure, check the slot with its DISK
LED lit in amber.
1. Set to the maintenance mode. See Chapter 3 (7.7.1 BMC – (7) Extended Functionality) for details.
2. Refer to Steps 3 to 4 in Chapter 2 (1.4 Overview of Installation and Removal) for preparations.
You can remove hard disk drive online (while the server is powered on).
3. Push the lever to unlock the drive, and open
the handle.
4. Hold the tray firmly and pull the tray toward
the front.
After removing a hard disk drive from the
slot, please wait about 10 seconds. After it is
removed from the slot, if it is inserted into
the slot again within 10 seconds, the fault
notification might be sent.
Express5800/A1040b, A2040b, A2020b, A2010b User's Guide
171
To Next Page
Loading...